Tuesday, May 3, 2011

Frisbee Bird Feeder

Bird feeder made from mainly recycled materials.
Approximate Time: 30 min - 1 hour



Supplies:
•2 bolts, washers, and nuts
1 empty grated cheese container
strong glue - like Goop
screw driver
2 Frisbees
drill
long needle nose tool
wire and "s" hook
Instructions:


I have two Chihuahuas and the last thing they would ever do is play with a Frisbee, so when we received two free ones I knew I had to come up with something. Here's what I did:

1.Drill holes in the center of the Frisbees top and bottom, also top and bottom of the container, the same size as the bolts you will be putting through.

2.Drill the bottom Frisbee with several holes for water drainage. Drill two small holes (across from each other) near the bottom of the container about 1/2 inch from the bottom. These holes should be about 1/3 inch wide.


3.Match up the container top to the underside of the top Frisbee and glue.

4.Put bolt through top and bottom set of holes, add washer and then the bolt, tighten. For top section have a loop of wire ready to wrap around the bolt before tightening. For the bottom use the needle nose to brace the bolt from inside the container while using the screw driver on the outside of the Frisbee.

5.Now it's ready to fill, turn the top Frisbee and the container cap should screw right off with it. Some bird seed may come out of the bottom feeding holes, but if the drainage holes are small the seed will stay in the Frisbee. Add your "s" hook and it's ready to hang.


Hope I have explained this well enough, if not let me know. I just set it out this morning so I haven't seen any birds yet, but once I do I am going to try to get some photos.

By NoRulesArt from Sunny FL


Friday, April 29, 2011

Tool Belt Dads card

This delightful card was made by forum member Crazysue.
A DAD card that resembles a tool belt.
Very creative Sue !
A tutorial can be found HERE
And another HERE

Thursday, April 14, 2011

Crystal Eggs

These wonderful crystal Eggs.
What a great way to spend time with a child and make your own crystals.
The whole kit id offered on Figgys site for only 20.00 dollars along with a few other great kits.
Check out the sites and enjoy the science !
Tools and Materials

•Blown-out eggshell (Get the How-To)
•Alum powder
•White glue
•Small paintbrush
•Plastic or glass container
•Egg dye
•Hot water
•Craft stick or spoon
•Latex gloves
•Drying rack or newspaper
Crystal Egg Geode How-To

1. Start by blowing out a large white chicken egg (Get the How-To) and splitting it in half, lengthwise. The egg can be cracked by striking it against a surface or cut with a small pair of scissors. Make sure the inside of the eggshell is clean and dry.

2. With a small paintbrush, apply white glue to the inside and cracked edges of each half of the eggshell and sprinkle with alum powder until completely coated. Set eggshell halves aside to dry overnight.

3. The next day, prepare your growing solution in a glass or plastic container by using a craft stick or spoon to mix 2 cups of very hot water (almost boiling) with an entire packet of powdered egg dye. Be sure to wear latex gloves to protect your hands from the dye. (Tip: Liquid food coloring can also be used to dye the geode -- 30 to 40 drops will adequately saturate the solution.)

4. Add 3/4 cup of alum powder to the hot dye bath and stir until completely dissolved. If there are remaining crystals in the bottom of the container, place the solution in the microwave for a few minutes to dissolve them. This will prevent alum from being drawn away from the geode.

5. Once the alum is completely dissolved, let the solution cool slightly (for about 30 minutes) and then submerge one of the dried, alum-coated eggshells in the growing solution, allowing it to rest on the bottom of the container with the inside of the shell facing up.

6. Set the container aside in a safe place overnight to allow the crystals to grow undisturbed. (Tip: The longer the eggshell is in the solution, the larger the crystals in the geode will be. Twelve to 15 hours will usually result in a perfect geode.)

7. The next day, remove the geode from the growing solution very carefully (as wet crystals are quite fragile), being sure to wear latex gloves to prevent the dye from staining your hands. (Tip: If you are not satisfied with the size of your geode crystals, return the geode to the growing solution and wait a day or two. As water evaporates from the solution, more alum will be deposited in your geode, increasing the size of the crystals.)
8. Place your geode on a drying rack or newspaper and allow to dry completely before handling.
9. To grow a second geode in the other half of the eggshell, simply re-dissolve the crystals remaining at the bottom of the growing solution in the microwave and follow the instructions above starting at step 5.

Additional Tips
Geodes can be grown without using egg dye. The resulting crystals are clear to milky white, like quartz.